News Center
GIS detection system for Very High Voltages

GIS detection system for Very High Voltages

GIS HIGH VOLTAGE TEST DEVICES • On-site commissioning, diagnostics and maintenance • Tests on high voltage GIS systems • AC resonant test system for on-site testing of GIS • Up to 600 kV voltage level. HIGH VOLTAGE TEST CABLE DEVICES • On-site commissioning, diagnostics and maintenance ... very high

[email protected]
News Detail
  • High Performance UHF Sensors for GIS - Think Grid

    2014-8-12High Performance UHF Sensors for GIS The sensor is designed for measurement of partial discharge (PD) signals with the UHF method. In addition it can be used as voltage detector. Main characteristics • Withstand voltages: between enclosure and HV conductor - depending on the GIS product type

    Get Price
  • VOLTAGE TRANSFORMERS FOR GIS APPLICATIONS

    2020-10-21When using single pole insulated inductive voltage transformers, it is very important to be aware that, if a circuit is being closed or during the decaying period of an earth fault, ferroresonance may occur. Ferroresonance can lead to the overheating and thermal destruction of the voltage transformer or high levels of voltages

    Get Price
  • In-situ insulation test of 400 kV GIS

    Because of very huge dimensions of GIS for nominal high voltages, it is not possible to carry out these tests in the factory and parts of the whole system have to be delivered and put together to

    Get Price
  • High-Voltage Testing on Site

    2020-5-8High-voltage (HV) tests and measurements are applied for two different reasons on site: When new equipment or systems are finally assembled on site, a quality acceptance test, usually a HV withstand test (more and more completed by PD or dielectric measurements), is required to demonstrate the necessary quality

    Get Price
  • Kontrolmatik

    GIS HIGH VOLTAGE TEST DEVICES • On-site commissioning, diagnostics and maintenance • Tests on high voltage GIS systems • AC resonant test system for on-site testing of GIS • Up to 600 kV voltage level. HIGH VOLTAGE TEST CABLE DEVICES • On-site commissioning, diagnostics and maintenance very high

    Get Price
  • High Voltage GIS Life Cycle Services

    2021-2-152 GIS Service | High Voltage Service Complete service portfolio from start-up to GIS is very highly reliable equipment. Though GIS requires less *CIGRE Evaluation of different switchgear technologies (AIS, MTS, GIS) for rated voltages of 52 V and above August 2009 6 GIS Service | High Voltage Service.

    Get Price
  • Partial Discharge Pattern Recognition of HV GIS by

    2019-7-1conditions. The expert system will reduce the time in finding out the root cause in the event of testing and in the service it will reduce the time to repair and keep GIS back into normal service conditions. Keywords—Partial discharge(PD), Gas insulated switchgear (GIS), neural network(NN), pattern recognition, phase resolvedCited by: 3

    Get Price
  • UHF partial discharge detection system for GIS

    The ultra-high frequency (UHF) method has been widely used in a gas-insulated system (GIS) for partial-discharge detection, and

    Get Price
  • Partial discharge monitoring system for cubic type GIS

    A novel method for generating high voltages from a low voltage DC source, by using a capacitor and inductor in a R, L, C resonant circuit has been developed with the consideration of using a high

    Get Price
  • Resonance circuit for GIS testing - OMICRON

    2019-9-16Gas-insulated switchgears (GIS) are compact and are, therefore, used in applications where space is limited. For commissioning of GIS a high-voltage (HV) withstand test is required in accordance with standards (IEC 62271-203). To date the test voltage needed for a withstand test has been produced by a resonance circuit. This test system

    Get Price
  • A Novel Approach for Partial Discharge Measurements

    2019-5-10in Gas Insulated Systems (GIS) using high frequency current transformers (HFCT). The system is based on the measurement of the induced PD currents in the GIS enclosure. In opposition to the existing antenna technologies that measure the radiated energy in the very high frequency/ultra-high

    Get Price
  • Insulation Coordination and Voltage Transients for

    2020-2-10Insulation Material for Medium High Voltage Systems •Air •Gas (i.e. SF6 GIS) •Liquids (i.e. oil in transformers) •Solids (i.e. paper, PVC in cables, plastics in switchgears) •Failures in insulation cause safety risks for human, fires and system outages •Failures may be due to insulation aging

    Get Price
  • IEC and IEEE Standards for High-Voltage Switchgear

    2008-1-22A common numbering system has been established for High-voltage switchgear. IEC 62271 is the basis of the standards of SC17A (High-voltage Switchgear) and SC17C (High- voltages higher than 52 kV (2008-01) 62271-207 Seismic qualification (2007-08) (very low probability of restrike) and new test

    Get Price
  • Partial Discharge Ultrasound Detection Using the

    GIS with regard to on-line partial discharge detection. In Proceedings of the Conference Record of the 1996 IEEE International Symposium on Electrical Insulation, Montreal, QC, Canada, 16–19

    Get Price
  • Pattern Recognition of GIS defects based on Envelope

    2008-10-282.2 Partial Discharge Detection System Fig.1 Partial discharge Detection System for GIS at UHF Based on Envelope extract The structure of partial discharge detection system was composed of built-in UHF sensor, wide-band amplifier, band-pass filter, GSM wave trap circuit, envelope extract circuit and high

    Get Price
  • UHF Partial Discharge Monitoring for 132 kV GIS

    132 kV GIS and the use of an active coupler is recommended. 1. Introduction A considerable body of research now exists showing the UHF method of partial discharge (PD) detection in 400 kV gas insulated substations (GIS) to be very sensitive [1,2]. GIS designed for lower operating voltages have smaller

    Get Price
  • Investigation of sensitivity of the ultra-high frequency

    detection techniques have been developed for different power equipment and for on- and off-line PD detections [5–10]. One of these techniques is the ultra-high frequency (UHF) PD detection for gas-insulated switchgear (GIS), which allows PD detection in GIS by sensing the PD-generated electromagnetic signals in the

    Get Price
  • A Novel Antenna for Partial Discharge Measurements in

    Since its introduction, back in the 80 s, the ultra-high frequency (UHF) method (300 MHz to 3 GHz) has been the most extensively used for partial discharge measurements in GIS, because it is more resilient to noise and easier to handle in comparison with the IEC conventional method [].The UHF system is based on the measuring of the ultra-highCited by: 5

    Get Price
  • Mitigation and Analysis of Very Fast Transient over

    2016-1-3withstand to very high voltages for very short time. However, as the duration of voltage increases, the withstand voltage falls off considerably. On the tning impulse level is close to unity for GIS, whereas for the conventional substations this ratio varies between 0.6 and 0.86. Although GIS has been in operation for

    Get Price
  • GIS

    2017-5-18A phased array probe is constructed from a number of very small elements arranged in a line or in a specific cluster design. By activating a number of the elements at once and applying specific voltages

    Get Price
  • GIS/GIL中金属微粒污染问题研究进展

    Translate this page2016-5-30LI Wei, SHU Na, LEI Ming, et al. Study on a rectangular plan spiral antenna for partial discharge detection in GIS [J]. High Voltage Engineering, 2014, 40 (11): 3418-3423. [68] 张晓星, 唐俊忠, 唐炬, 等. GIS中典型局放缺陷的UHF信号与放电量的相关分析 [J]. , 2012

    Get Price
  • Design of Earth Grid for a 33/11kV GIS Substation at a

    The earthing system provides a low impedance path for electric current to the earth without exceeding the operating limits of equipment.Furthermore, it ensures that in the event of a fault,the current is easily dissipated into the earth without damaging the equipments or exposing personnel on site to dangerous touch and step voltages…Cited by: 1

    Get Price
  • Analysis and Mitigation Methods for VFTO’S and VFTC’S

    For these cases the resulting over voltages are in the range of 1.7 pu and reach 2.0 pu for very specific cases. In case of a high speed disconnector the maximum trapped charge could be 1.0 pu and the highest overvoliages reach values up to 2.5 pu. In some cases extreme high values of more than 3 pu have been reported.Author: P.Ramakrishna Reddy

    Get Price
  • International Journal of Scientific Engineering

    2016-9-9cal detection tubes as discussed in the earlier section. However, in a GIS the diagnostic gases would be greatly diluted by the large volume of SF much longer times would be needed to detect the PD. Ther fore, it appears that this approach is not very sensitive to be considered for PD monitoring. 4 DIAGNOSTIC TECHNIQUES FOR PD DETECTION

    Get Price
  • FAST TRANSIENT OVERVOLTAGES IN GIS CAUSED BY

    2013-1-1A. REIN: When operating a disconnecting switch in a power generating system you may get a phase opposition situation if the voltages on the two sides of the circuit breaker are not synchronized. When operating the disconnecting switch, the AC voltage across this could be very high because of the coupling through the

    Get Price
  • Enhanced continuous, real-time detection, alarming

    2020-1-30Partial discharge monitor for GIS Enhanced continuous, real-time detection, alarming and analysis of partial discharge events life of the GIS. The PDMG-RH system is used for continuous, online partial discharge monitoring and pick up high transient over-voltages when disconnect switches or

    Get Price
  • Sample preparation for atomic-resolution STEM at low

    2012-3-1It is argued that a relative specimen thickness t/λ between 0.2 and 0.5 is required for very high-end analytical microscopy, resulting in a typical absolute sample thickness between 40 nm and 10 nm for low-kV microscopes. Producing such thin samples that still contain a substantial proportion of undamaged material is a

    Get Price
  • Status review on partial discharge measurement

    2004-4-1Flat plate sensors are used for PD measurements in the GIS. Fig. 2 shows the cross-sectional view of the disc sensor, where C 1 is the capacitance between the inner conductor of the GIS and circular metallic plate of the sensor and C 2 is the capacitance between the sensor plate and the GIS enclosure. In the lower

    Get Price
  • Action Plan To Fight Human Trafficking In The Works | GIS

    (Stock Photo) The Office of the Attorney General (OAG) is working assiduously on its action plan to combat human trafficking, and a key component of this involves the training of all officers involved in the fight. Permanent Secretary in the Office of the Attorney General, Yvette Goddard, emphas

    Get Price
  • Spatio-Temporal Analysis of Landuse/Landcover Change

    Detecting change on the face of the globe using GIS (Geographic Information System) aided by remotely sensed imagery is now becoming an indispensable tool in managing the resources of our planet. The present study with the help of GIS and remote sensing (RS) is also a similar attempt in recording and quantifying change

edge-iconRelated News
toTop
Click avatar to contact us
Chat Online